How much does the Slant/Fin CHS-i Series cost installed in Richmond?

Slant/Fin units typically fall in the $7,500 - $11,500 range before rebates. The installed price in Richmond depends on venting, gas-line work and whether it's a like-for-like swap or a conversion. We provide a fixed written quote after an in-home assessment.

Is the Slant/Fin CHS-i Series a good fit for a Richmond home?

Low-elevation site with townhomes, condos and detached homes; drainage and venting are key. The CHS-i Series (95% AFUE, 85,000-399,000 BTU/h) is sized to your measured heat loss and hot water demand rather than square footage alone, so we confirm fit during a free assessment.

Do you install and service the Slant/Fin CHS-i Series in Richmond?

Yes — we install, replace, repair and maintain the Slant/Fin CHS-i Series across Richmond and Greater Vancouver. Every job is completed by a licensed BC gas fitter with permits and full commissioning.

Slant/Fin CHS-i Series · Richmond, BC

Slant/Fin CHS-i Series in Richmond

VHS Victory & CHS condensing combi — the CHS-i Series installed, replaced, repaired and serviced across Richmond by licensed, gas-certified technicians.

95% AFUE efficiency85,000-399,000 BTU/hTypical range $7,500 - $11,500

Call 778-909-5731 Free Quote

Licensed & Insured Authorized-Quality Installs Serving Richmond Since 1999

Quick answer

The Slant/Fin CHS-i Series is a 95% AFUE combi unit (85,000-399,000 BTU/h). Installed in Richmond,Slant/Fin systems typically range $7,500 - $11,500 before FortisBC and CleanBC rebates. We install, replace, repair and service it with licensed BC gas fitters, permits and commissioning included.

Modulating condensing wall-hung boiler. Slant/Fin is a long-established American heating manufacturer whose VHS Victory condensing combi and CHS wall-hung boilers serve Canadian homes with proven hydronic engineering.

Richmond sits on the Fraser delta at near sea level, where condensate drainage and venting details matter. Its mix of Steveston detached homes and Brighouse condos suits compact combi boilers well. We size every Slant/Fin CHS-i Series to your home's real heat loss for correct output and peak efficiency across Richmond.

Full CHS-i Series specs & pricing

Dimensions, warranty, flow rate and features.

View CHS-i Series details

Why the Slant/Fin CHS-i Series suits Richmond homes

Low-elevation site with townhomes, condos and detached homes; drainage and venting are key. Slant/Fin is a strong match here:

Established American manufacturer
VHS Victory combi
Stainless heat exchanger
High modulation
Quiet operation

Our Slant/Fin CHS-i Series services in Richmond

Slant/Fin Installation in Richmond Slant/Fin Replacement in Richmond Slant/Fin Repair in Richmond Slant/Fin Maintenance & Servicing in Richmond

Richmond neighbourhoods we serve

Brighouse / City CentreStevestonTerra NovaHamiltonWest RichmondBridgeport

Rebates for Slant/Fin boilers in Richmond

Most Slant/Fin 95% AFUE condensing models qualify for FortisBC and CleanBC rebates when installed by a licensed, program-registered contractor in Richmond. We confirm eligibility and handle the application as part of your installation.

This is not a DIY repair

Combi boilers are gas-fired appliances regulated under the BC Safety Standards Act. Opening the unit, touching the gas valve, or working on the flue without a valid BC gas-fitter licence is both unsafe and illegal. Diagnosing the fault is helpful — fixing it should always be left to a certified technician.

Call 778-909-5731