How much does the Camus Hydronics DynaFlame cost installed in Richmond?

Camus Hydronics units typically fall in the $10,000 - $18,000 range before rebates. The installed price in Richmond depends on venting, gas-line work and whether it's a like-for-like swap or a conversion. We provide a fixed written quote after an in-home assessment.

Is the Camus Hydronics DynaFlame a good fit for a Richmond home?

Low-elevation site with townhomes, condos and detached homes; drainage and venting are key. The DynaFlame (96% AFUE, 300,000-3,000,000 BTU/h) is sized to your measured heat loss and hot water demand rather than square footage alone, so we confirm fit during a free assessment.

Do you install and service the Camus Hydronics DynaFlame in Richmond?

Yes — we install, replace, repair and maintain the Camus Hydronics DynaFlame across Richmond and Greater Vancouver. Every job is completed by a licensed BC gas fitter with permits and full commissioning.

Camus Hydronics DynaFlame · Richmond, BC

Camus Hydronics DynaFlame in Richmond

Canadian high-capacity condensing boilers — the DynaFlame installed, replaced, repaired and serviced across Richmond by licensed, gas-certified technicians.

96% AFUE efficiency300,000-3,000,000 BTU/hTypical range $10,000 - $18,000

Call 778-909-5731 Free Quote

Licensed & Insured Authorized-Quality Installs Serving Richmond Since 1999

Quick answer

The Camus Hydronics DynaFlame is a 96% AFUE combi unit (300,000-3,000,000 BTU/h). Installed in Richmond,Camus Hydronics systems typically range $10,000 - $18,000 before FortisBC and CleanBC rebates. We install, replace, repair and service it with licensed BC gas fitters, permits and commissioning included.

High-capacity condensing boiler/water heater for large buildings. Camus Hydronics is a Canadian (Ontario) manufacturer of high-capacity condensing boilers and water heaters - the Advantus and DynaFlame lines - engineered for commercial, strata and large-residential heating across Canada.

Richmond sits on the Fraser delta at near sea level, where condensate drainage and venting details matter. Its mix of Steveston detached homes and Brighouse condos suits compact combi boilers well. We size every Camus Hydronics DynaFlame to your home's real heat loss for correct output and peak efficiency across Richmond.

Full DynaFlame specs & pricing

Dimensions, warranty, flow rate and features.

View DynaFlame details

Why the Camus Hydronics DynaFlame suits Richmond homes

Low-elevation site with townhomes, condos and detached homes; drainage and venting are key. Camus Hydronics is a strong match here:

Canadian-built (Ontario)
High-capacity condensing
Advantus & DynaFlame lines
Cascade-capable
Commercial-grade durability

Our Camus Hydronics DynaFlame services in Richmond

Camus Hydronics Installation in Richmond Camus Hydronics Replacement in Richmond Camus Hydronics Repair in Richmond Camus Hydronics Maintenance & Servicing in Richmond

Richmond neighbourhoods we serve

Brighouse / City CentreStevestonTerra NovaHamiltonWest RichmondBridgeport

Rebates for Camus Hydronics boilers in Richmond

Most Camus Hydronics 95% AFUE condensing models qualify for FortisBC and CleanBC rebates when installed by a licensed, program-registered contractor in Richmond. We confirm eligibility and handle the application as part of your installation.

This is not a DIY repair

Combi boilers are gas-fired appliances regulated under the BC Safety Standards Act. Opening the unit, touching the gas valve, or working on the flue without a valid BC gas-fitter licence is both unsafe and illegal. Diagnosing the fault is helpful — fixing it should always be left to a certified technician.

Call 778-909-5731